This is the exact opposite of my experience. We’ve been using codium in my org and 9/10 times it’s garbage and they will not allow anything that is not on prem. I’m pretty consistently getting recommendations for methods that don’t exist, invalid class names, things that look like the wrong language, etc. To get the recommendations I have to cancel out of auto complete, which is often times much better. It seems like it can make up for someone who doesn’t have good workflows, shortcuts and a premium ide, but otherwise it’s been a waste of time and money.

It’s been a while since I’ve printed but I think both my sidewinder and voron do this. I don’t remember having it after switching to abs. Painted on supports and wider extrusions helped a ton if I remember correctly. Good luck!

At least the song is 🔥

It could be a lot of things. Temperature is a big one, are you letting the bed heat up completely for a consistent amount of time before each print, could heat be impacting your measurements, some things measure different when heated a bit? You probably aren’t printing enclosed, but my voron for example expands upwards almost an entire layer over the first hour of printing. Is there an intermittent air flow that could be impacting how hot your bed really is? Have you verified there is no slop or backlash in your z lead screws and connections? I had decent results on my sidewinder using POM anti backlash nuts. Same for the stability of your measuring tool. Have you checked that it’s not z tilt from turning off the motors between prints?