Tuvo Tornado has been practically plug and play for me. Be ready to spend a lot of time designing, printing, testing, redesigning, reprinting. Not necessarily because of the printer, but just a normal part of the process.

And don’t be afraid to print part of a design and stop the print just to verify the footprint or general dimensions are good. It takes extra time and guaranteed ‘failure’ from a fully usable part, but much better than waiting a full 5-10 hours for a full print just to realize the holes on the first layer are offset, or the walls are 5mm too close for your use case.

It’s not cheating, especially if it’s anonymous. More like the same lines of watching porn, just a more personal version.

If you were sending them to someone for some other reason it would be closer to cheating.

Narrator: It is the point of the strategy

‘But we told the pediatric hospital we were going to bomb them. All those children should have gone somewhere else’ - Israel (probably)