I often do lots of planning and writing in org-mode as an outline, so everything is basically headings that I can move around, promote/demote etc. Then when I want to paste it into Confluence I use this to export a subtree as markdown.
It’s brute-force, naive, shitty code and all that, but it works.
And, sometimes to get the level of markdown headings / bullet points correct I have to run this on a higher level org heading and then pick just a bit of the output to paste into the wiki.
One thing that doesn’t work well in the Confluence editor in particular is if you have a code block below a markdown bullet point.
I often do lots of planning and writing in org-mode as an outline, so everything is basically headings that I can move around, promote/demote etc. Then when I want to paste it into Confluence I use this to export a subtree as markdown.
https://github.com/jplindstrom/dotemacs/blob/master/config/mode-org.el#L352
It’s brute-force, naive, shitty code and all that, but it works.
And, sometimes to get the level of markdown headings / bullet points correct I have to run this on a higher level org heading and then pick just a bit of the output to paste into the wiki.
One thing that doesn’t work well in the Confluence editor in particular is if you have a code block below a markdown bullet point.